3D planning

See it first. Then install.

Lighting control only meets the requirements properly if the sensors sit where people and vehicles actually move. That's why we plan every project in our own 3D software.

Your building in 3D

We scale your floor plan and rebuild the building with walls, racking and mounting heights. Then we place sensors, zones and background light and send people and forklifts through the hall.

  • Detection areas from manufacturer diagrams, not rule-of-thumb radii
  • People and forklift routes, the light runs ahead
  • Sun position and daylight control
  • Test the failure of individual sensors

What the planning checks

Around 25 rule checks run over every plan before it reaches you.

Coverage per room

Every room is checked for detection. Gaps and dark corners show up before installation.

Mounting heights

Every sensor sits within the manufacturer's permitted height.

Wireless network

Sensors are assigned to gateways; ranges and node counts are checked.

What you get

A basis you can present internally.

Planning documents

Plans with sensors and zones, bill of materials and a document accompanying the quote.

A film of your building

A simulation to show, e.g. to management or the owner.

Commissioning record

After installation: every sensor with address, measured value and acceptance status.

Frequently asked questions

What do you need from us?

A floor plan as PDF or photo, the mounting heights and a photo of the luminaire or driver label. We clarify the rest during the site survey.

Is the planning binding?

The planning is the basis for the quote. You see in advance how the control works, then you decide.

Does 3D planning replace a lighting calculation?

No. 3D planning defines sensors and zones. The illuminance of the luminaires stays the same; for new luminaires we calculate separately.

Can we use the film internally?

Yes. The film shows your building and helps convince decision-makers. We can anonymise it on request.

Getting started

From your question to a finished plan.

Free initial consultation, one contact person.

Send a photo of the driver labelWe check free of charge whether your luminaires can be retrofitted.
Add your floor planWe turn it into a 3D model with sensors and zones.
Planning and quoteYou see the result in 3D first, then you decide.